Waterous CM Series, Руководство по установке, Страница: 51 / 56

51
|
56
Safety Introduction Product Overview Installation
Installing the Transfer Valve Actuator—Manual Override
1
2
Installing the Control Rod
Use the illustrations and instructions to install the
control rod between the control panel and actuator.
Note:
The control rod is usually supplied by the
installer and cut to length, but an optional
control rod is available from Waterous.
1 Install U-joints onto each end of the control rod,
then secure the joints with spirol pins.
2 Install the U-joint onto the remote shaft, then
secure the joint with a spirol pin.
3 Install the other U-joint onto the actuator shaft,
then secure the joint with a spirol pin.
1
3