Waterous CM Series, Руководство по установке, Страница: 17 / 56

17
|
56
Safety Introduction Product Overview Installation
Manual Transfer Valve Actuator
Feature Feature Description Description
1 Connector This connects to the extension cable that goes between the control panel and encoder—DT04-4P.
2 Encoder This monitors the position of the actuator and sends it to the control panel.
3 Gear case shaft This connects to the control rod that goes between the control panel and actuator. A U-joint is used to connect the shaft to
the control rod.
4 Actuator housing This houses the actuator's mechanical components.
5 Top mounting bracket This is used to mount the actuator on the top of the pump.
6 Bottom mounting bracket This is used to mount the actuator on the bottom of the pump.
1 1
4
5
6
2 2
4
3