WaterLogic WL900 Скачать руководство пользователя страница 1

 

WL900

 Manual 

                                                      Page 4 – Revision:  4-14-2021 

SAFETY ALERT SYMBOLS 

 

Read and follow all safety information carefully.  The signal words used in this manual are 

selected as shown below and based on an assessment of the degree of potential injury or 

damage (severe or minor) and the occurrence of injury (definitely occurs or has the potential to 

occur) when the warning is ignored: 

 

 DANGER!   

Indicates a situation which, when not avoided, results in death or severe injury.   

 

 WARNING!   

Indicates a situation which, when not avoided, has the potential to result in death or 

severe injury; and/or severe property damage.  

  

 

 CAUTION!   

Indicates a situation which, when not avoided, results or has the potential to result in 

minor injury; and/or minor property damage. 

 

 

 

SAFETY PRECAUTIONS 

 

 

Basic safety precautions should be followed, including the following: 

Ensure all Local, State, and Federal Laws and Codes including health and safety guidelines are 

met when installing 

Waterlogic

 Equipment.   Only qualified service technicians should attempt 

installation and service of 

Waterlogic

 Equipment.  Always read the entire operating instructions 

before using the appliance and save these instructions for future use. 

 

DANGER!  

This product can cause death or severe injury if incorrectly operated, installed or 

maintained. 

The installation, maintenance, sanitizing and any repair must be performed by 

qualified persons trained by Waterlogic International or their approved distributors only.  Do 

not remove any panel or cover to protect against electrical shock and exposure to UV 

radiation.   

 

DANGER! 

ELECTRICAL SHOCK HAZARD

.  

Always use a dedicated and properly grounded 

outlet.  Unit should be protected by ground-fault circuit interrupter (GFCI) or residual current 

device (RCD) having a rated residual operating current not exceeding 30mA.  Use only 

Waterlogic supplied power cord. Never use extension cords or power strips to connect unit. 

Do not use if the power supply cord is damaged. Always unplug from power supply prior to 

servicing. 

 

WARNING!

  

AUTHORIZED USE ONLY.  

This appliance is to be used for its intended purpose as 

described in this manual.  Untrained individuals who use this manual assume the risk of any 

resulting property damage or personal injury.  This appliance can’t be used by children and 

persons with reduced physical, sensory or mental capabilities or lack of experience.   

 

WARNING!

  

DO NOT OPERATE IF DAMAGED.

  Unplug and isolate water supply if abnormal 

conditions exist. Contact Waterlogic or authorized dealer for repair, service, and installation 

to avoid hazards.  

 

Содержание WL900










Отзывы: