30
Waterford E65-1 Emerald Direct Vent Freestanding Gas Stove
Copy of the Lighting Plate instructions
OPERATING INSTRUCTIONS
pilot does not remain lit, repeat operation
allowing a longer period before releasing
gas control knob.
4)
When the pilot stays lit, turn the gas knob
further counterclockwise to the "ON" posi-
tion.
5)
Use the thermostat or remote control to turn
on the unit.
6)
Rotate the flame height regulator to adjust
the flame height higher or lower.
SHUTDOWN
PROCEDURE
1)
Use the thermostat or remote control to turn
off the main burner.
2)
Turn the main gas control clockwise to the
"OFF" position to turn off the pilot (push
knob in slightly).
3)
Turn off all electric power to appliance if
service is to be performed.
FIRST FIRE
The
FIRST FIRE
in your stove is part of the paint
curing process. To ensure that the paint is
properly cured, it is recommended that you burn
your fireplace for at least four (4) hours the first
time you use it with the fan on. When first
operated, the unit will release an odour caused
by the curing of the paint and the burning off of
any oils remaining from manufacturing. Smoke
detectors in the house may go off at this time.
Open a few windows to ventilate the room for
a couple of hours. The glass may require
cleaning.
DO NOT ATTEMPT TO CLEAN THE GLASS
WHILE IT IS STILL
HOT
!
Note: When the glass is cold and the
appliance is lit, it may cause con-
densation and fog the glass. This
condensation is normal and will
disappear in a few minutes as the
glass heats up.
During the first few fires, a white film
may develop on the glass front as part
of the curing process. The glass should
be cleaned or the film will bake on and
become very difficult to remove. Use a
non-abrasive cleaner and NEVER clean
the glass while it is hot.
DO NOT BURN THE APPLIANCE
WITHOUT THE GLASS FRONT IN
PLACE.
