Waterco Fulflo Pressure Pump
Assembling the Waterco Fulflo Pressure Pump Unit
I
pg 03
3. If you have purchased a pressure pack;
a. Wrap 3-4 turns of Teflon tape onto the male threaded end of the
Pressure Pack and screw on the Tee fitting.
b. Wrap 3-4 turns of Teflon tape onto the male threaded end of the controller.
Take the Pressure Pack and Tee Fitting and screw onto the pump controller.
4. Readjust the direction of the pump controller and the tee fitting if necessary. The brass barrel
union should be tightened using a suitably sized wrench. All other connections should be hand
tight.
WARNING
Do not tighten any connections by twisting the pressure pack. Over-tightening may result.
Figure 1: Contents of the Boxes
Pump and Controller
Pressure Pack and Tee Fitting
(Optional)
Upon purchase, some minor assembly of the unit will be required before installation.
Follow the steps below and the assembly will be finished before you know it.
1. Locate the pump in the desired position.
2. Place the controller onto the pump so it is facing the desired position and tighten the brass barrel
union.
