Water Control WHRO-700, Руководство по установке

Страница: 17 / 20

17
APPENDIX A – TAKING WATER QUALITY MEASUREMENTS
1) Remove the protective cap
2) Turn the TDS meter on. The
ON/OFF switch is located on the
panel
3) Immerse the meter into the
water/solution up to the max
immersion level (2”). If
necessary, use a clean plastic
cup to capture sample.
4) Lightly stir the meter to dislodge any air bubbles
5) Wait until the display stabilizes. Once the reading stabilizes (approx. 10 seconds), press the HOLD button to
view the reading out of the water
6) If the meter displays a flashing “x10” symbol, multiply the reading by 10
7) After use, shake off any excess water from your meter and replace the cap
For additional information regarding your handheld TDS meter, visit
www.hmdigital.com
APPENDIX B – WIRING SCHEMATIC