Testing the VISTA Vehicle Kit Installation
Testing the VISTA Vehicle Kit Installation
To test that all components are properly installed and connected:
1. Power on the system.
Note:
The system may power on automatically when you insert the 7.5
amp fuse.
2. Verify that both the Smart Power Switch and the VISTA WiFi Base have power:
a. The switch shows power through light activity on its ports.
b. The base shows power through its LEDs.
Note:
The system takes 60 to 90 seconds to fully boot up.
3. Wait for the system to fully boot up (60 to 90 seconds).
4. Dock the VISTA WiFi or VISTA XLT camera in the WiFi Base and allow the camera and base to
pair with each other.
The WiFi Base left LED blinks green several times when the camera and base have paired.
5. Verify that the VISTA WiFi or VISTA XLT camera is in communication with the WiFi Base:
a. Undock the camera.
b. Wait 30 seconds while the camera runs through its information sequence on the display.
c. Verify that the
Wi-Fi Signal Strength
icon shows on the display.
6. If the camera has already been configured by the agency's Evidence Library software, verify
that it starts recording when one of the connected external inputs activates, for example,
emergency lights/siren or the driver's side door opens.
For more information about...
Using VISTA WiFi or VISTA XLT as part of the VISTA Vehicle Kit, see
.
VISTA WiFi or VISTA XLT behavior in general, see the
VISTA HD Wearable Camera User Guide
.
Configuring VISTA WiFi or VISTA XLT cameras, see the agency's Evidence Library software
documentation.
VISTA Vehicle Kit
WGD00161 Revision A
21
