Doc. P/N:
WSP-009-004
Version:
V1.3
Issue Date:
August 2013
Page 58 of 62
Operator Manual
Ź
Verify that the Transfer Task is receiving data on each activated port by checking that the
$FWLYLW\OLJKWÀDVKHVJUHHQQRWUHG7KH7UDQVIHU7DVNFDQEHIRXQGLQWKH:LQGRZV7DVN
Bar. You can verify that the correct NMEA sentences are arriving on each port by selecting
‘Monitor’. This will print out the received NMEA onto the window for that particular port.
Ź
)LQDOO\LIWKHVHDÀRRULVQRWXQLIRUPO\ÀDW\RXFRXOGVHHUDSLGFKDQJHVLQWKHVRQDUGLVSOD\
ZLWKHDFKSLQJDVWKHVKLSPRYHVDFURVVWKHVHDÀRRU$VWKHUHLVQRKHDYHRUSLWFK
FRPSHQVDWLRQRQWKLVGLVSOD\LWZLOORIWHQPRYHXSDQGGRZQDQGLIWKHVHDÀRRUFKDQJHV
DQJOHLWZLOODOVRDSSHDUWRUROODELW,I\RXDUHXQVXUHFKHFNWKDWWKHVHDÀRRUUHPDLQVÀDWRQ
DÀDWVHFWLRQRIVHDÀRRUDQGUHPHPEHUWKDWDYHUWLFDOVKLIWLVH[SHFWHGLIWKHUHLVYHVVHOUROO
pitch and/or heave.
7.10 The mode button animates as if pinging but nothing happens.
What is wrong?
Check your GPS is on. This can be validated by checking the network input screen or transfer
task diagnostic displays.
Increase the gain, and range. Can you see noise on the Sonar Display? If not, reset the power
to the Transceiver, and reset the PC and retry. If this problem persists and there are no error
messages, contact your dealer. If you are getting an error message or messages, look at the
relevant information for the error message in the section of the FAQ.
Ensure that the Transducer has not been disconnected from the BTxR, both the receiver cables
and the transmit cables need to be connected in order for the WASSP system to operate. If
problems persist after a full system shutdown and power up then contact your dealer.
