Page 64 of 102
Page 65 of 102
Doc: DRX Installation
Version: 7.1 January 2021
Doc: DRX Installation
Version: 7.1 January 2021
DRX INSTALLATION MANUAL
DRX INSTALLATION MANUAL
7.3. CONNECTING HYPACK TO THE DRX
HYPACK needs to be purchased from your local HYPACK dealer. See
for details.
Install HYPACK 2016A or later. Refer to HYPACK manual for details.
1.
Go to
PREPARATION
and
select
HARDWARE
SETUP
.
2.
INCLUDE
HYSWEEP Survey.
NOTE: All GPS and sensor data should be connected to the DRX.
DRX supplies all required data to HYPACK over the ethernet link.
NOTE: Refer to Knowledge Base for guidelines on system configuration
with HYPACK.
See “Appendix I - Product Registration, Support and
3.
Select
HYSWEEP
SURVEY
in the tree
on the left.
4.
Then select
WASSP
DRX
.
5.
Select
ADD
(WASSP DRX will
now be in the
list of Installed
devices).
6.
Close HYPACK
Combined
Hardware and save
changes.
7.
Select
SURVEY
in
the menu.
8.
Select
HYPACK
SURVEY AND
HYSWEEP SURVEY
.
9.
Once connection
is established DRX
control can be
performed through
the
WASSP
DRX CONTROL
accessed from
HYSWEEP
TOOLS
menu.
NOTE: Offsets recorded under
“5.1. Commissioning Step 1: Ship
need to be applied in HYPACK directly.
