Wasp Wasp WDI7500, Руководство по продукции

Страница: 272 / 310

References
262 Wasp WDI7500/WWS750
Bluetooth Features
Bluetooth Pin Code
This option specifies the 4-character or 16-character pin code to be used
for authentication of the Bluetooth link. To set the pin code:
1. Scan the
ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
ming Mode, then enable "Bluetooth Security Mode" on page 218 .
2. Specify the desired pin code length (4 or 16) by scanning the appropri-
ate barcode in "Select PIN Code Length" on page 218.
3. Determine the desired characters. For example, D254 or
STOR12345678135M.
4. Convert the characters to hexadecimal using the ASCII Chart on the
inside back cover of this manual.
5. Go to page 218 and Scan the barcode: SET 4 CHAR PIN CODE or SET 16-
CHAR PIN CODE.
6. Scan the appropriate alphanumeric characters from the keypad in
Appendix D, Keypad , representing the hexadecimal entries determined
in the steps above. You will hear a two-beep indication after the last
character.
If you make a mistake before the last character, scan the CANCEL barcode
to abort and not save the entry string. You can then start again at the
beginning.
7. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
ming Mode.
Changing the pin code setting will unlink the devices. If the Automatic
Configuration Update is set to the default enabled setting, the devices
must only be relinked. If the Automatic Configuration Update is set to the
disabled setting, the Pin Code setting must also be updated in the Base
Station. After the Base Station has been updated, the devices must be
relinked.
Table 48. Bluetooth Pin Code Setting Examples
STEP ACTION EXAMPLES
1 Desired Setting
D254 STOR12345678135M
2
Convert the characters
to hexadecimal
44 32 35 34 53 54 4F 52 31 32 33 34 35 36 37 38 31 33 35 4D
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SET Bluetooth PIN CODE
5
Scan 8 or 32
Alphanumeric
Characters From
Appendix D, Keypad
44323534 53544F5231323334353637383133354D
6 Scan ENTER/EXIT PROGRAMMING MODE