Wasp 2D, Справочное руководство

Страница: 48 / 200

Data Editing
4-2 DuraLine™ 2D Imagers
• You can add any prefix or suffix from the
ASCII Conversion Chart
(Code Page 1252) on page A-4
, plus Code I.D. and AIM I.D.
• You can string together several entries for several symbologies at
one time.
• Enter prefixes and suffixes in the order in which you want them to
appear on the output.
To Add a Prefix or Suffix:
Step 1.
Scan the Add Prefix or Add Suffix symbol ( page 4-4 ).
Step 2.
Determine the 2 digit Hex value from the Symbology Chart (included
in
"Symbology Chart" on page A-1) for the symbology to which you
want to apply the prefix or suffix. For example, for Code 128, Code ID
is “j” and Hex ID is “6A”.
Step 3.
Scan the 2 hex digits from the Programming Chart on page B-5 of this
manual or scan 9 , 9 for all symbologies.
Step 4.
Determine the hex value from the ASCII Conversion Chart (Code
Page 1252) on page A-4 , for the prefix or suffix you wish to enter.
Step 5.
Scan the 2 digit hex value from the Programming Chart on page B-5
of this manual.
Step 6.
Repeat Steps 4 and 5 for every prefix or suffix character.
Step 7.
To add the Code I.D., scan
5
,
C
,
8
,
0
.
To add AIM I.D., scan
5
,
C
,
8
,
1
.
To add a backslash (\), scan
5
,
C
,
5
,
C
.
Step 8.
Scan Save to exit and save, or scan Discard to exit without saving.
Repeat Steps 1-6 to add a prefix or suffix for another symbology.
Example: Add a Suffix to a specific symbology
To send a CR (carriage return)Suffix for UPC only:
NOTE
To add a backslash (\) as in Step 7, you must
scan 5C twice – once to create the leading back-
slash and then to create the backslash itself.