Starline XU
OPERATOR USE
START
•
Turn on at wall.
•
Ensure the Wash / Drain Filter Basket (1) is in place and shut the door.
•
Press the Power switch, the switch will glow red and the machine will fill automatically.
OPERATION
•
Load rack into the machine and shut door.
•
Press either Cycle 1 (1min) or Cycle 2 (2min) to start the dishwasher.
•
Cycle buttons glow green while machine operates.
•
When Cycle lights goes out, the cycle is complete.
NOTE: The machine may be started while the rinse water is being heated – the machine will continue to run the wash cycle until the
rinse water is up to temperature.
SHUT DOWN - EVERY NIGHT
•
Open the door, press the Drain switch and leave the door open.
•
Allow to drain for approximately 1 minute or until the tank is empty.
•
Turn the Drain and then the Power switches off.
•
Once the machine has cooled down, clean the wash tank, then remove and rinse Wash / Drain Filter Basket (1)
•
Check and clear any waste from inside the drain sump.
•
Replace Wash / Drain Filter back into machine.
CLEANING – AT LEAST ONCE A WEEK
•
Remove, rinse and replace when machine has cooled down:
Wash / Drain Filter Basket
1
Wash / Rinse Arm Thumbscrew
2
Rinse
Arms
3
Wash
Arms
4
•
Unscrew thumbscrew (3) to remove Wash Arms (4) and Rinse (3) Arms.
•
Inspect Arm and ensure that all jets are clear.
•
Use a small object (e.g. toothpick) where necessary to remove any blockages.
SUGGESTED BEST PRACTICE
Pre-rinse
Scrape and/or rinse glasses in cool water.
Chemical
Use a good quality non foaming commercial detergent and drying agent – do not use domestic detergents
which will cause the machine to foam.
Servicing
Commercial dishwashers should be serviced at least every 6 months or 15,000 cycles.
POWER DRAIN WASH RINSE CYCLE 1 CYCLE 2
ON TEMPERATURE TEMPERATURE
Service
0800 STARLINE
Parts
09 829 0930
Starline XU Series-4
Oct-23
1
2
4
4
3
