Warner Manufacturing
13435 Industrial Park Blvd.
Minneapolis, MN 55441
Step-Up Bench Replacement Parts
Tools Required
1. Drill
2.
1
⁄
4
" Drill Bit
3. 2
7
⁄
16
" Wrenches
4. #2 Phillips Screwdriver
5.
3
⁄
8
" Wrench (Rubber Feet only)
6. Hammer
7. Center Punch
WARNING:
Failure to read and follow all instructions
may result in serious injury or death.
Check for all worn or damaged parts before starting.
Replace parts with Warner brand parts only.
Hinge
Part #10314 replacement hinge part for all Warner Step-Up Benches
1. Use hammer and center punch on rivets to center the drill.
2. Drill out old rivets with
1
⁄
4
" drill bit (CAUTION: Do not over-enlarge the holes).
3. Replace hinge with
1
⁄
4
-20 screws and nuts provided.
4. Tighten hinge bolt (check and retighten bolt in one week to ensure bolt is tight).
Spreaders
Part #10297 replacement part for 2' Bench #10225 and 2
1
⁄
2
' Bench #10226
Part #10298 replacement part for 3' Bench #10227 and 4' Bench #10228
1. Use hammer and center punch on rivets to center the drill.
2. Drill out old rivets with
1
⁄
4
" drill bit (CAUTION: Do not over-enlarge the holes).
3. Replace spreader with
1
⁄
4
-20 screws and nuts provided.
4. Tighten bolts and then loosen
1
⁄
4
turn to allow the bracket to pivot (check daily
and retighten if necessary).
DO NOT over-tighten or bench will not fold properly.
Rubber Feet
Part #10296 replacement rubber feet for all Warner Step-Up Benches
1. Use
3
⁄
8
" wrench and #2 Phillips screwdriver.
2. Remove worn feet.
3. Replace with new feet and the screws and lock nuts provided.
WARNING:
Check all bolts daily to ensure safe operation.
If you need assistance or have any questions, please call Warner Customer Service at 1-800-444-0606.
Part #10314
Part #10297
Part #10298
Part #10296
