WARN INDUSTRIES
62060 Rev. B1
PAGE 1
Always use extreme caution when drilling on any vehicle. Make sure that all fuel lines, brake lines, electrical wires, and other objects
are not punctured or damaged when/if drilling on the vehicle. Thoroughly inspect the area to be drilled (on both sides of material) prior
to drilling, and relocate any objects that may be damaged. Failure to inspect the area to be drilled may result in vehicle damage,
electrical shock, fire or personal injury.
Always wear safety glasses when installing this kit. A drilling operation will cause flying metal chips. Flying chips can cause eye
injury.
Always use extreme caution when cutting and trimming during fitting.
Always remove jewelry and wear eye protection.
Always use appropriate and adequate care in lifting components into place.
Always insure components will remain secure during installation and operation.
Always tighten all nuts and bolts securely, per the installation instructions.
WARNING
Failure to observe these instructions could lead to severe injury or death.
Failure to observe these instructions could lead to severe injury or death.
Failure to observe these instructions could lead to severe injury or death.
Failure to observe these instructions could lead to severe injury or death.
Failure to observe these instructions could lead to severe injury or death.
Your safety, and the safety of others, is very important. To help you make informed decisions about safety, we have provided installation
and operating instructions and other information on labels and in this guide. This information alerts you to potential hazards that could hurt
you or others. It is not possible to warn you about all potential hazards associated with this product, you must use your own good judg-
ment.
CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURY OR
EQUIPMENT DAMAGE. READ AND UNDERSTAND ALL SAFETY PRECAUTIONS AND
OPERATING INSTRUCTIONS BEFORE INSTALLING AND OPERATING THIS PRODUCT.
This guide identifies potential hazards and has important safety messages that help you and others avoid personal injury or death. WARN-
ING and CAUTION are signal words that identify the level of hazard. These signal words mean:
WARNING
signals a hazard that could cause serious injury or death, if you do not follow recommendations.
CAUTION signals a hazard that may cause minor to moderate injury, if you do not follow recommendations.
This guide uses NOTICE to call attention to important mechanical information, and Note: to emphasize general information worthy of
special attention.
INSTALLATION INSTRUCTIONS
FOR JEEP REAR BUMPERS
TJ P/N 61854, YJ P/N 61857,
CJ P/N 61860
NOTES:
On some TJ and YJ models, it may be necessary to loosen the gas tank skid plate to allow
for enough hand room to access the inner bolt hole locations
VI. INSTALLATION
1. Remove the rear bumper from vehicle.
·
On TJ models, discard bumper and mounting hardware.
·
On YJ models, discard bumper and mounting hardware.
·
On CJ models, discard bumper and mounting hardware.
2. Install new, Warn, rear bumper on vehicle.
·
On TJ models, use the supplied 3/8" bolts, lockwashers, and washers in all 8 mounting
locations. Torque 3/8" bolts to 35-38 ft lbs. Insert the two spacers, one on each side, between
the bottom bumper tab and the bottom of the frame. Install the bottom bumper bolts, using the
2 supplied 7/16" bolts, lockwashers, and washers, torque 7/16" bolts to 42-45 ft lbs.