WARN INDUSTRIES
PAGE 3
39526 Rev B1
indicated in Figure #3. Notice that not all the holes will be used in the attachment of the Frame Mounting
Bracket to the frame. This is because this bracket is use on other bikes that use the other holes. Use only
the holes as shown in Figure #3. The “tabs” should be oriented toward the front of the bike.
FIGURE #2: INSTALLING U-BOLTS ONTO FRAME
Install the 5/16” Nylock nuts onto the U-bolt.
For the 450S model
, lift up the “right” side of the bracket
and install the remaining 5/16” U-bolt and it’s respective 5/16” Nylock nuts, and tighten all the 5/16” nuts
to approximately to 15ft-lb (20N-m).
For the 450ES model
, lift up the “right”side of the bracket and either
mark the hole(as indicated in Figure #3) and drill through the skid plate, or drill through the hole(as
indicated in Figure #3), through the skid plate using the Frame Mounting Bracket as a template. This is
done on the 450ES models inorder to install the remaining “right” U-bolt.
FIGURE #3: FRAME MOUNTING HOLE LOCATIONS
Holes used for the 450 model bike
Drill into skid plate through
this hole(450ES models)
“Left”
side
“Right”
side
Frame Mounting
Bracket
