Warmtec EWE+ 1000 Wi-Fi, Руководство пользователя

Страница: 40 / 84

Overheat protection
The heater is equipped with a protection that turns off the heater in case of
overheating. If it worked, turn off the heater, unplug the device and let it cool down
completely. Check that the air inlets or outlets are not blocked, then try to restart the
heater.
If the heater does not work or the safety device turns it off again, return the heater to
the service center for inspection and possible repair.
Tilt sensor
The device is equipped with a tilt sensor located on the PCB board. When the heater
tilts about 15 degrees, the power will be automatically turned off.
If the temperature set on the heater is 1°C higher than the current one in the room,
the heater will be turned on and the icon will appear on the display .
Activation of the heater
Press and hold the button to activate the child lock. Press and hold the button
to turn off the child lock. The function works both in standby mode and when the
heater is on.
Child lock
Press and hold the button to activate the open window function. The activation
of the function is confirmed by displaying the icon on the device's display. To
disable the open window function, press and hold the button The operation of
the open window function is if the temperature in the room drops by 5°C within 20
minutes, the heater will stop heating and the icon will flash on the display. To
restore the heater's operation, press and hold the button . After a while, the
open window icon will stop flashing and the heater will operate in the mode before
the function was activated.
Open window function
Activation of the standby mode for connection with Wi-Fi
Connecting the heater to the mobile application via Wi-Fi is possible when the
standby mode for connecting to the Wi-Fi network is active. This is confirmed by a
flashing icon on the device's display. To enter the Wi-Fi standby mode, press and
hold the button . After about 5 seconds, the flashing icon will appear on the
display. More about connecting to a Wi-Fi network in the chapter Connection set
up/Wifi control
40