2.1. General Safety Instructions
• All EMBER heating panels are only suitable for use as a heating element. Any improper use can present a significant danger
to people, animals and the environment.
• EMBER heating panels are not intended to be used by people (including children) with reduced physical, sensory or mental
abilities or lack of experience and/or knowledge, unless they are supervised by a person responsible for their safety or have
received instructions on how to use the device.
• All heating panels must be kept away from children. Children should be supervised to ensure they do not play with
the device.
• EMBER heating panels are not suitable for use in rain or wet conditions, under water, and for any non-intended use.
• For all EMBER heating panels, please observe the following installation instructions (see Section 3).
• Each EMBER heater has a built-in safety switch that turns off the heating element automatically if it is overheating. By
unplugging the unit and waiting for about 10 to 15 minutes, the safety switch is activated automatically and the unit is
operational again.
2.2. Special Safety Instructions
• DO NOT COVER. Warning: To avoid overheating, the heater must not be covered. Never cover the EMBER heating panel. This
can cause heat buildup.
• The heater is very hot when in use (depending on model, up to 125° C or 257ºF). Contact could lead to serious burns.
• Each EMBER heater is equipped with a power cord and plug. By using an optional adapter, you can operate the heater with
a room thermostat. Make sure that nobody can trip over the cable. Protect the unit from overloading the circuit breaker, and
operate the equipment only as specified on the nameplate.
• Do not use the EMBER heating panel if the power cord or plug is damaged. This should be checked before each use. Do not
drag or tear the main cable. Do not scrub the cable, and do not clamp the cable. Neither the cable nor the plugs may be
repaired or replaced. In case of damage, contact the manufacturer or distributor.
• Never dip EMBER heating panels into water or put them in water. Also, people should never touch the heating element
while they are in the bathtub or shower. Do not use this device near a bathtub shower or swimming pool.
• The heating panel can only be operated in a permanently mounted position (for more information on mounting, see Section
3.1.).
• In case of damage to the heating panel or the circuit cable, immediately disconnect it from the circuit. (For further
information about the warranty process, see Section 8).
• To prevent damage and accidents, never open the device (see the detailed information described in Section 3.5.). If the
device is opened, warranty and liability claims are not approved.
3
Safety Notes Before First Use
Section 2
