WarmFlow WS18, Инструкция пользователя

Страница: 62 / 97

58
Alarm Screen Possible Cause(s) Suggested Action(s) Action By
User Engineer
The wood pellets loaded into the
combustion pot are poor quality, damp or
contaminated.
The appliance has run out of wood pellets.
Too many or too few pellets have loaded
into the combustion pot.
The photocell is dirty/wet and cannot
measure sufficient light level (Lux).
The ignition system is faulty and has failed
to ignite the pellets in the combustion pot.
(Ignition failure only).
The fuel delivery system is faulty.
The exhaust fan is faulty and the draught
act. value is not matching the draught set.
The pressure sensor is faulty.
Follow the instructions on the screen:
• Wait for the counter on the screen to reach
0 seconds.
• Open the front casing door (refer to Section
2.5.3 Cleaning Procedure, STEP 4)
• Wait for the green light beside the isolator
switch to illuminate.
• Open the combustion door. (Refer to
Section 2.5.3 Cleaning Procedure, STEP 5)
•
Remove the combustion pot and empty it.
• Re-install the combustion pot.
• Close the combustion door.
• Close the front casing door.
Ensure the pellet hopper contains sufficient dry,
uncontaminated ENPlus A1 pellets.
Remove the photocell and clean the clear “eye”
at the end before replacing it in its holder.
Test the operation of the igniter, igniter fan,
auger motor, auger, exhaust fan, pressure
sensor and repair/replace if necessary.
The combustion door has been left open.
The combustion door switch is faulty.
The combustion door handle and locking
mechanism is faulty
Close the combustion door until the door
interlock is heard clicking into place.
Test the operation of the combustion door
switch and repair/replace if necessary.
Check the combustion door handle and locking
mechanism for damage and repair if necessary.
Table 10: Alarms Schedule 2