WARMBOARD COMFORT SYSTEM // GAS
10
Manifold Cabinet
PREPARATION
Before installing the controls, an electrician
MUST
review the electrical page of the WCS Design
Drawings and note necessary materials, locations,
voltage and amperage of all electrical components.
TUBING & LABELING
Included with your controls is a series of labels to
adhere to each supply and return loop beneath the
manifold. Appropriate use of these labels will ensure
each loop is accurately labeled for diagnostic issues.
These color-coded labels coincide with the color
labels on the side of the Manifold Controller (MC)
and those displayed in your WCS Design Drawings.
CONTROLS
Warmboard Controls consist of the following:
f
120 volt thermostats (one per heating zone)
f
120 volt Manifold Controller (one per manifold)
f
24 volt solenoid valve loop actuators
(one per loop, powered by the MC)
f
Smart Reset Controller (inside Warmsource-N/P)
INSTALLING THE MC
f
Use the provided screws to mount each Manifold
Controller (MC) inside the manifold cabinet specified
by the WCS Design Drawings
f
Plug the MC into the nearby 120 volt outlet
INSTALLING THE ACTUATORS
f
Attach an actuator to each return port on the
return manifold
f
Connect each actuator wire to the appropriate port
on the side of the MC, which is pre-labeled and color
coded. Refer to the WCS Design Drawings as needed
Before installing the controls, you
MUST
disable Construction Mode by removing the
jumper on the SRC.
