Product information
Additional loads on the product in the form of hanging
objects or guy ropes could damage the product or cause
it to become detached from the wall and are therefore
not permitted. WAREMA will not be liable for any ensuing
damage.
The intended use also includes observing these instructions
and adhering to the service requirements they describe.
Optional:
Integrated awning with easyZIP guidance
The product is an external textile sun shading system that
may be used for thermal protection, glare control and visual
privacy on vertical glass surfaces. The product reduces the
incidence of light and optimises the use of solar energy.
The product is intended to be used to protect against the
sun, not the rain.
Optional:
LED strips
The product consists of an electronic LED lighting device
(warm white light) for outdoor installation. In the slat roof,
the power supply of the LED strips is provided via the WMS
Dimmer smart.
Optional:
RGB strips
The product consists of an electronic lighting device make
of RGB LEDs for outdoor installation. In the slat roof, the
power supply of the RGB-LED strips is provided via the
RGB Dimmer ZigBee.
Optional:
Radiant heater
The product is designed to generate radiant heat outdoors.
The product is connected to a mains voltage of 230 V/50 Hz
via the WMS Plug receiver power.
Optional:
WMS Weather station plus
The product enables the wireless control of sun shading
product and is equipped with a sensor for brightness,
precipitation, temperature and wind speed. The
weather station may be connected to a mains voltage of
230 V/50 Hz and must be set to the value specified for the
product.
2.2
Parts description
1
2
3
5
4
1
Pole
4
Integrated awning
with the easyZIP
guidance (optional)
2
Beams
5
Integrated LED strips
(optional)
3
Slats
Fig. 1:
Parts description using Lamaxa L70 as an example
(without wall connection)
2.3
Electrical data
Data for electric drive of slat roof
Parameter
Value
Current consumption [A]
0.9 A
Rated voltage
230 V/50 Hz
Degree of protection
IP 44
Short-term operation (S2)
4 min
Emissions sound pressure level
LpA
≤
70 dB(A)
*
*
The sound pressure level LpA in a standard
installation of the product on a test stand is
≤
70 dB(A). This value may vary depending on the
specific installation.
Page 6 | 32
2029839 [Rev. 9 - en]/2021-10-11
