Operating and installation instructions
EWFS Haustechnik PL
Keep for future use!
Valid from 01 December 2017
866084_g•en•2017-12-01
We reserve the right to carry out improvements
1
General information
Fig. 1
EWFS Haustechnik PL
The EWFS Haustechnik PL radio receiver is an electronic
control device for the direct actuation of 230 V AC sun
shading drives. It can receive move commands from
EWFS-compatible transmitters. The motor and receiver are
supplied through the same supply line. The receiver can
be operated by means of an overriding sun shading con-
trol system. Because of its compact design, the receiver
can be installed in a flush-mounted junction box.
Intended use
The EWFS Haustechnik PL radio receiver was developed
to control sun shading systems. The approval of the
manufacturer must be obtained for uses outside of the
purposes listed in these instructions.
Safety instructions
WARIRG
W
The electrical installation must be per-
formed by a certified electrician in accord-
ance with the electrical installation regula-
tions published by the Wssociation of Ger-
man Electrical Engineers (VDE 0100) or the
standards and regulations of the country
in which the device is being installed. The
electrician must observe the installation
instructions included with the electrical
device.
WWARIRG
If hazard-free operation cannot be assumed,
the device may not be started or must be de-
activated. This is the case if
the housing or the supply lines show signs of
damage
the device is no longer working.
WATIIR
C
Never activate buttons on your transmitter
arbitrarily without visual contact to the sun
shading product. Children may not play with
this product - Remote controls or transmit-
ters must not get into the hands of children!
The range of radio controls is restricted by legal regula-
tions for radio systems and through structural factors.
Adequate radio reception must be ensured when plan-
ning the project. This applies especially if the radio signal
must penetrate through walls and ceilings. The control unit
should not be installed in the immediate vicinity of metal
components (steel beams, steel-reinforced concrete, fire
door).
n
Therefore, check that the receiver is functioning prop-
erly before the final installation.
Strong local transmitter systems (e.g. baby monitors or
neighbouring transmitters) can interfere with the reception.
Function
PL (permanent mode)
This operating mode is useful for fabric products and
roller shutters: The sun shading product responds to the
operation of the "Up" or "Down" button on the transmitter
by moving in the corresponding direction and immediately
goes into lock mode. The button may be released immedi-
ately and the sun shading system will move until the fixed
run time of 3 minutes has expired. To release the lock and
stop the motor, the button for the opposite direction of
movement or the stop button must be pressed briefly.
