12
Tripod BO-DS112
www.wano.pl
4.1
Button introduction
Control board
:
“ENT”, “INC”, “ESC”, and “DEC”
ENT:
Enter ENT setting or to determine the current modified value
ESC:
Back to previous menu
4.2.
Menu setting
Step1:
Press “
ENT
“for 3s to enter, press “
INC
”, “
DEC
” to choose F01 menu list
Step 2:
Press “
ENT
” to enter the time setting
Step 3:
Press “
INC
”, “
DEC
“to set the numbers
Step4:
After finish setting, press “
ENT
“to save
Step 5:
Press
“ENT
”, it will asthmatically quit from main menu
4.3.
Parameter setting instruction
Control board connected to power, LED display shows <Run>
[F 0 1] Set the passage time:
Within this time, pedestrian can pass the gate.
If no pedestrian pass, the gate will close asthmatically after times up( default time is 5 seconds
）
[F 0 2] Access is permitted and prohibited:
0: R&L all prohibited
1: All permitted
2:Left prohibited, right permitted
3: Right prohibited, left permitted. (default is 0
）
[F 0 3] Turnstile working mode:
0: Free passage
1: Arm down when power off (default 1)
[F 0 4] Memory function
:
When open or close the entrance gate, if there is memory function, normally sued when one pedestrian swipe the card but
without permitted pass, the gate can save other pedestrians’ cards information.
Prohibited: 00 - when the first pedestrian swipe care and pass the second pedestrian need to swipe card too.
Permitted: 01- means the number of people allowed to swipe is the number of people allowed to pass in succession.
Permitted “means whoever swipes a valid card then they are allowed to pass (default is prohibited: 00)
[F 0 5] Repeatedly open and close the switch testing:
It is mainly used for testing the stability and aging of brake control panel.
Note: in test mode, press the ESC key to exit the test
4. Menu Parameter Setting
