W&H MN-111, Руководство по устранению неисправностей

Страница: 14 / 22

14 MN-111 | Service book | Errors and Troubleshooting MN-111 ENG Rev08 | 2019/06/21 | © 2019 W&H Sterilization Srl
Errors
Code Description Possible causes Checks and actions
217 Chamber heater sensor error or
disconnected. Chamber heater sensor
disconnected. Check the connection to the main board and the relevant wires.
If the error persists, see next step.
Chamber heater sensor failure.
Main board failure.
See error "216" on the previous page, same causes.
230 Steam generator temperature
sensor error Steam generator sensor failure See Test instructions service book, chapter SPECIFIC TESTS FOR INDIVIDUAL
COMPONENTS, Steam generator temperature sensor (TABLE POINT 1 and 3).
If it is necessary, replace the sensor.
If the problem persists, see next step.
Main board failure See Test instructions service book, chapter SPECIFIC TESTS FOR INDIVIDUAL
COMPONENTS, Steam generator temperature sensor (TABLE POINT 1 and 2).
If it is necessary, replace the main board.
231 Steam generator temperature
sensor error or disconnected Steam generator sensor
disconnected Check the connection to the board and the relevant wires.
If the error persists, see next step.
Steam generator sensor failure
Main board failure
See error "230" above, same causes.
240 Steam generator heating element
error. Heating element thermostat
operated. Reset the chamber heater thermostat.
Check the thermostat continuity (0Ω).
If it is open, replace the component.
Heating element not properly
connected. Check the connections and the wires between the heating element and the main board. If
the error persists, see next step.
Main board failure. See Test instructions service book, chapter SPECIFIC TESTS FOR INDIVIDUAL
COMPONENTS, Heating element of the steam generator and safety thermostat (TABLE
POINT 2).
If it is necessary, replace the main board.
Heating element failure. See Test instructions service book, chapter SPECIFIC TESTS FOR INDIVIDUAL
COMPONENTS, Heating element of the steam generator and safety thermostat (TABLE
POINT 3).
If the problem persists, see next step.
See Test instructions service book, chapter SPECIFIC TESTS FOR INDIVIDUAL
COMPONENTS, Heating element of the steam generator and safety thermostat (TABLE
POINT 4).
If it is necessary, replace the steam generator.
241 Steam generator heating element
error (coil L1). Heating element failure.
Main board failure.
See error "240" above, same causes.
242 Steam generator heating element error or disconnected (coil L2). See error "240" above, but all tests and actions apply to L2.
243 Steam generator heating element error (coil L2). See error "240" above, but all tests and actions apply to L2
243 Steam generator heating element
error (coil L2). See error "240" above, but all tests and actions apply to L2
300 Timeout in LEV phase
(Pchamber<Penviroment-0.10
bar)
Levelling set points not achieved.
HEPA filter clogged/dirty.
EV3 clogged/dirty
HEPA filter tube line clogged/dirty.
F2 filter clogged/dirty
"Emergency door opening" on page 9
Check if the sterilizer is installed in accordance to the technical specification reported in
the Instructions for use.
Replace component if needed and/or fix the problem.