W&H Med MN-111, Инструкция по эксплуатации

Страница: 42 / 100

42 Lexa | Instructions for Use | MN-111 Med ENG Rev14 | 03/04/2023 | © W&H Sterilization Srl
Managing printers
SELECT AND CALIBRATE A LOCAL LABEL PRINTER
1
On the homepage, tap > > >
2
Tap : the local printer is located automatically.
3
Tap to center the printout properly in the label area.
4
Tap to print a test label.
5
If the printout is not duly centered, tap or to center it
horizontally (x) and vertically (y).
6
If necessary, tap to print another test label and repeat step
4.
7
Tap to confirm the settings and go back to the previous
page.
SELECT A SHARED LABEL PRINTER
Note : function available only if the LAN/Wi-Fi connection has been activated
(optional).
1
Ensure the sterilizer to which the printer is physically
connected is ON and no cycle is running.
2
From that sterilizer, tap > .
3
Depending on the LAN connection, take note of the Ethernet or
Wi-Fi IP address.
4
Do not switch OFF the sterilizer until the whole procedure is
complete.
5
From the sterilizer from which the printer is not physically
connected, tap homepage >
> > > .
6
Tap .
7
Tap the text box and enter the IP address previously noted.
8
Tap to confirm.
9
From the sterilizer to which the printer is connected, confirm
the printer sharing.
10
Tap again to print a test label.
Label printer usage (optional)
CAUTION! For your safety and the safety of your patients
use a storage time compliant with the recommendations of
the manufacturers of the containters/packaging used, and
with applicable norms and rules.
FUNCTION AVAILABILITY
The first time you access the Label Printer ( ) menu, you will be
requested to enter an activaction code. To require the activation