Iron
Copper
Aluminium
Non-biodegradable plastics
Fibre glass for printed circuits
Ferrite
Batteries
CFC-free refrigeration gas
Electrical and electronic equipment (WEEE)
The manufacturer shall not be chargeable for any disposal of the apparatus at the end of its
working life.
In line with EU Directive 2002/96/EC for waste electrical and electronic equipment
(WEEE), this electrical product must not be disposed of as unsorted municipal
waste. Please dispose of this product by returning it to your local muni
point
for
recycling.
3. OPERATION
All the functions of the blast chiller model GBF
follow are being preset as described in the following
START UP:
To start, press and hold the
power button on the “Stand-
the Status bar is full and the message “Please
Wait” appears on the screen.
At the start up the controller ask for a Screen
calibration. Screen calibration starts in the
upper left and ends bottom right corner.
Press each crosshair starting in the upper
left, then the top right, lower left, and finishing
in the lower right
.
If you missed calibration,
press the yellow burst to begin calibration
Press the clock icon mark on the main
screen in order to set the current date and
time: On the “Date/Hour” screen, use the
up/down arrows to set the current date,
hour, and minute. It is critical to set this
correctly. Once the date and time has been
set, press the icon on the right of the screen
The unit will run automatically at plug
showing
Prechilling
mode to chill down
cavity. The precilling cavity set point is
F- The main Page will show :
Fibre glass for printed circuits
Electrical and electronic equipment (WEEE)
The manufacturer shall not be chargeable for any disposal of the apparatus at the end of its
In line with EU Directive 2002/96/EC for waste electrical and electronic equipment
(WEEE), this electrical product must not be disposed of as unsorted municipal
waste. Please dispose of this product by returning it to your local muni
point
for
recycling.
All the functions of the blast chiller model GBF-15+ETLWM are already installed and the steps to
follow are being preset as described in the following points:
To start, press and hold the
-By” screen until
the Status bar is full and the message “Please
At the start up the controller ask for a Screen
calibration. Screen calibration starts in the
upper left and ends bottom right corner.
Press each crosshair starting in the upper
left, then the top right, lower left, and finishing
If you missed calibration,
press the yellow burst to begin calibration
.
Press the clock icon mark on the main
current date and
On the “Date/Hour” screen, use the
up/down arrows to set the current date,
hour, and minute. It is critical to set this
Once the date and time has been
the right of the screen to confirm.
will run automatically at plug-in,
mode to chill down
cavity. The precilling cavity set point is -40°
The main Page will show :
Prechilling
;
The manufacturer shall not be chargeable for any disposal of the apparatus at the end of its
In line with EU Directive 2002/96/EC for waste electrical and electronic equipment
(WEEE), this electrical product must not be disposed of as unsorted municipal
waste. Please dispose of this product by returning it to your local municipal collection
point
for
recycling.
15+ETLWM are already installed and the steps to
