Wallgate SNC-02, Руководство по эксплуатации продукта

Страница: 22 / 24

Revision 3
22
SNC-02 Product Manual
6.1 Operation
1. Fully open the water supply isolating tap.
2. Operate the shower.
3. If the shower is activated by Wallgate controls, i.e. WDC100 or WDC200 the
default run time for the shower is 60 seconds.
NOTE: Further settings can be found in the WDC product manuals which are
also available on the Wallgate website.
NOTE: This product offers no form of temperature control.
6.2 Maintenance
The ceiling shower plate is polished stainless steel and can be cleaned using warm
soapy water or a stainless-steel cleaner. A suitable limescale remover applied to the
manufacturers guidelines is also a safe method for cleaning.
NOTE: Bleach, spray cleaners and abrasive cleaners may damage the surface
and internal parts of the shower.
For ease of cleaning, the spray plate can be removed from the external plate. The
assembly is shown in figure 2.
1. Unscrew the 2x security screws to release the internal plate and an O-ring.
This can be cleaned separately following the guidelines above.
2. After cleaning reinstall the O-ring, plate, and screws. To do this set the O-ring
on the underside of the internal plate.
3. Push the plate and O-ring into the opening, aligning the 2x holes in the plate
with those on the housing.
NOTE: For maximum vandal resistant properties it is recommended to reapply
Loctite 2700 WRAS approved thread sealant to M4 screws before refitting.