Wallenstein WXR700 Series, Руководство оператора

Страница: 21 / 48

WXR720/L, WXR740/L
Log Splitter
Controls
21
5.3 Stroke Limiter Accessory
The Stroke Limiter accessory improves productivity when
splitting shorter pieces. It stops the cylinder from fully returning
to the home position.
5.3.1 Stroke Limiter Adjustment
1. Place a typical sized log on the splitter bed, then start the
log splitter.
2. Using the hydraulic control, move the splitting wedge up to
the log, but stop approximately 3" (8 cm) from it.
3. Shut off the engine. Make sure the splitter-control lever is in
the stop position.
4. Loosen the hex set screw on the rod adjusting collar, and
move the rod up to the splitting wedge or push block (this
is the set position at which the splitting wedge or push
block stops on the return cycle). Tighten the hex screw.
5. Test the set up by cycling the splitting wedge through its
path. Split a log then put the hydraulic lever into the retract
position. The lever should trip the hydraulic control and the
splitting wedge should stop at the set position. Adjust as
required.
00713
1
2
4
3
3"
(8 cm)
N
Figure 10 –
Set the stroke limiter accessory