Operating Instructions
WX530
Trailer Wood Splitter
30
6.15 Connecting a Tow Vehicle
1.
Keep bystanders are clear of the machine.
2.
Make sure there is enough room and clearance to safely
back up to the machine.
3.
Slowly back the tow vehicle until the coupler on the hitch
and ball are aligned.
00207
Fig. 29 –
Ball Hitch Aligned
4.
Lift the hitch and place the coupler over the ball on the
hitch.
5.
Flip the latch to lock the coupler around the ball.
6.
Pull out the jack stand snap lock pin and raise the jack
stand to its stowed position. Install snap lock pin to secure
it.
7.
Raise the rear jack stand and secure with the snap lock pin.
8.
Cross safety chains under trailer tongue and attach
securely to the tow vehicle hitch.
9.
Connect the wiring harness for the lights (as equipped).
10.
Reverse the above procedure when unhooking.
6.16 Storing the Wood Splitter
After the season's use and the wood splitter is going to be
put away in storage, it should be thoroughly inspected and
prepared. Repair or replace any worn or damaged components
to prevent any unnecessary down time at the start of next
season. The wood splitter can have a long, trouble-free life by
following these steps:
IMPORTANT! Refer to the engine manufacturer's manual
for information specific to engine storage.
1.
Fully retract the cylinder ram.
2.
Add a stabilizer to the fuel tank. Top up the tank and
run the engine outdoors for 10 minutes to be sure that
treated gasoline has replaced the untreated gasoline in the
carburetor.
3.
Thoroughly wash the machine using a pressure washer to
remove all dirt, mud, debris, and residue.
4.
Inspect the wedge, cylinder ram, push block and wear
plates for damage or entangled material. Repair or replace
damaged parts. Remove all entangled material.
5.
Touch up all paint nicks and scratches to prevent rusting.
6.
If the splitter is to be stored for longer periods
(over 6 months), follow the engine manufacturers
recommendations for storage preparation.
7.
Store the machine in an area away from human activity.
8.
Select an area that is dry, level and free of debris to park the
wood splitter.
9.
If the wood splitter is not stored inside a building, cover
with a waterproof tarp. Tie securely in place.
10.
Do not allow children to play on or around the stored
machine.
6.17 Removing from Storage
1.
Review and follow the Pre-operation Checklist. See
2.
