Wallenstein WX470, Руководство оператора

Страница: 22 / 36

6.7.2 Horizontal Splitting
1. Place wood or log on the splitter.
2. Push control lever forward and hold to split wood.
3. Release the lever when the log splits or cylinder reaches full
stroke and stops.
4. Pull the lever back to retract the wedge. The detent holds
the lever until the cylinder fully retracts, allowing hands-free
operation.
00644
Fig. 13 –
Hydraulic Control Valve Positions
IMPORTANT! Do not hold the valve lever to extend or
retract the cylinder once it has reached the end of its stroke.
Doing so can overheat the oil.
5. If the log is large enough to require another split, reposition
and repeat steps.
00749
Fig. 14 –
Single Blade Wedge
6. Pile the split wood close to the working area, but do not
allow pieces to pile up and clutter the area. A cluttered
working area can lead to tripping and an accident.
6.7.3 Vertical Splitting
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
1. Place wood or log on the splitter anvil.
2. Push control lever down and hold to split wood.
3. Release the lever when the log splits or cylinder reaches full
stroke and stops.
4. Pull the lever back up to retract the wedge. The detent holds
the lever until the cylinder fully retracts, allowing hands-free
operation.
5. If the log is large enough to require another split, reposition
and repeat steps.
00748
Fig. 15 –
Log Placement
Operating Instructions
WX470
Skid Steer Wood Splitter
22