Operating Instructions
WX370
3-point Hitch Wood Splitter
24
3.
Release the lever when the log splits or cylinder
reaches full stroke and stops.
4.
Pull the lever back to retract the wedge. The detent
holds the lever until the cylinder fully retracts,
allowing hands-free operation.
00644
Fig. 14 –
Hydraulic Control Valve Positions
IMPORTANT! Do not hold the valve lever to
extend or retract the cylinder once it has reached
the end of its stroke. Doing so can overheat the
oil.
5.
If the log is large enough to require another split,
reposition and repeat steps.
00749
Fig. 15 –
Single Blade Wedge
6.
Pile the split wood close to the working area, but
do not allow pieces to pile up and clutter the area.
A cluttered working area can lead to tripping and
an accident.
6.5.3 Vertical Splitting
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
1.
Place wood or log on the splitter anvil.
2.
Push control lever down and hold to split wood.
3.
Release the lever when the log splits or cylinder
reaches full stroke and stops.
4.
Pull the lever back up to retract the wedge. The
detent holds the lever until the cylinder fully
retracts, allowing hands-free operation.
5.
If the log is large enough to require another split,
reposition and repeat steps.
00748
Fig. 16 –
Log Placement
