Controls
WX350, WX360
3-point Hitch Wood Splitter
18
Retract
•
Push the lever up to retract the wedge. The valve
detent holds the lever in Retract allowing a hands-
free return cycle.
•
The valve lever spring-returns to Neutral when
released from auto-retract.
00732
Fig. 7 –
Retract Wedge
5.2 Stroke Limiter Accessory
The Stroke Limiter accessory improves productivity
when splitting shorter pieces. It stops the cylinder from
fully returning to the home position.
5.2.1 Stroke Limiter Adjustment
1.
Place a typical sized log on the splitter bed, then
start / apply power to the wood splitter.
2.
Move the wedge up to the log, but stop
approximately 3" (8 cm) away from it.
3.
Shut off the engine. Make sure the hydraulic
control lever is in the neutral position.
4.
On the rod adjusting collar, loosen the hex set
screw and move the rod up to the push block /
wedge. (This is the set position at which the wedge
stops on the return cycle.) Tighten the hex screw.
5.
Test the set up by cycling the wedge through its
path. Split a log then put the valve lever into the
return (detent) position. The lever should trip the
hydraulic control so the wedge stops at the set
position. Adjust as required.
00734
3"
(8 cm)
Fig. 8 –
Stroke Limiter
