Wallenstein WP845, Руководство оператора

Страница: 48 / 72

6.16 Split Wood Discharge
Split wood is pushed off the end of the splitter chute as each
additional log is split. Set the splitter chute height to pile
firewood on the ground, on a conveyor, or in a trailer or wagon.
For more information, see
Set the Splitting-Wedge Height on
page 37 .
6.17 Position the Next Log
The log in the machine is repeatedly cut and becomes too short
to winch forward. At this point, winch another log in behind the
current log and use it to push the current log into the cutting
area.
1. Make sure the log in the machine is stable.
2. Push the winch gear lever to the RH side (away from the
operator) to disengage the winch gear.
3. Slightly pull the rope out of the winch by hand.
4. Detach the hook from the winch strap.
5. Pull the rope out to the next log.
6. Wrap the winch strap around the log. You may need to roll
the log onto the strap using a log peavey.
7. Attach the hook to the winch strap.
01219
Fig. 43 –
Use the next log to push the previous one
8. Pull the winch gear lever to the LH side (toward the
operator) to engage the winch gear.
9. Push and hold the winch control lever down to pull the log
onto the entry chute. Position the log against the previous
log. Use the next log to push the previous log forward to the
log-length guide.
10. After a few log cuts, complete the following:
-
Repeat steps 1 through 4.
-
Move the winch strap to the far end of the log.
-
Repeat steps 6 through 8.
-
Push and hold the winch control lever down to pull the
log forward to the log-length guide.
6.18 Position the Last Log
CAUTION!
Risk of serious injury. Never attempt to push a
log through the stabilizer opening by hand. The
stabilizer could drop suddenly and cause serious
injury. Always use the appropriate procedure and
tools to push or pull a log through the opening.
When you process the last log, you will find it is too short to
winch into the machine. Use a hookaroon or peavey to push the
last log forward to the log-length guide.
Be aware of the heavy log stabilizer and use extreme caution
when processing the last log.
01220
Fig. 44 –
Use an appropriate tool to push the last log forward
Operating Instructions
WP845 / WP875
Trailer Firewood Processor
48