Wallenstein WP240, Руководство оператора

Страница: 22 / 60

2.20 Replace Damaged Safety Signs
1. Keep safety signs clean and legible at all times.
2.
Replace safety signs that are missing or have
become illegible.
3. Parts that were replaced with a safety label on
them must also have the safety sign replaced.
4. Replacement safety signs are available from your
authorized Distributor or Dealer Parts Department
or the factory.
2.21 How to Install Safety Signs
1. Be sure that the installation area is clean and dry.
2. Be sure temperature is above 50 °F (10 °C).
3. Determine exact position before removing the
backing paper.
4.
Remove the smallest portion of the split backing
paper.
5. Align the sign over the specified area and carefully
press the small portion with the exposed sticky
backing in place.
6. Slowly peel back the remaining paper and carefully
smooth the remaining portion of the sign in place.
7.
Small air pockets can be pierced with a pin and
smoothed out using the piece of sign backing
paper.
3. Familiarization
3.1 To the New Operator
The Wallenstein Wood Processors are designed to
connect to and pull logs to the machine, position for
cutting with a chainsaw and split the resulting log. The
operator should be familiar with the machine prior to
starting.
It is the responsibility of the owner or operator to
read this manual and to train all other operators
before they start working with the machine. Follow
all safety instructions exactly. Safety is everyone's
business. By following recommended procedures,
a safe working environment is provided for the
operator, bystanders and the area around the work
site. Untrained operators are not qualified to use
the machine.
Many features incorporated into this machine are the
result of suggestions made by customers like you.
Read this manual carefully to learn how to use the
winch, chainsaw and wood splitter safely and how
to set it to provide maximum operating efficiency. By
following the instructions in conjunction with a good
maintenance program, your Wood Processor will
provide many years of trouble-free service.
3.2 Safe Condition Procedure
• Clear splitting chamber
• Wind in winch cable
•
Shut off hydraulics
• Ensure all components have stopped moving
•
Shut off the engine
• Remove and pocket the ignition key
• Ensure the wheels are chocked to prevent
movement
IMPORTANT! Make sure all operators understand
how to put the machine in Safe Condition before
working with this machine.
3.3 Operator Orientation
IMPORTANT! When describing controls, the
directions for left-hand, right-hand, backward and
forward as mentioned throughout this manual, are
determined when standing at the control panel.
Familiarization
WP240-WP270
3-Point Hitch Firewood Processor
22