Wallenstein LXG300 Series, Руководство оператора, Страница: 36 / 52

Operating Instructions
LXG300 Series
Grapples
36
8. Activate the winch to pull log up to the grapple.
9. Make sure the log is stable, then disengage the winch gear.
10. Pull out the rope slightly to detach. Remove the strap.
Spooling in with no load
IMPORTANT! If spooling the rope in with no load, keep a
light tension on it to avoid entanglement. Make sure the rope
is tightly and evenly layered.
• Lay the rope on the ground so it cannot kink or get tangled
on obstacles as it is spooled in.
• Make sure the rope layers tightly and evenly on the drum.
Have an assistant help.
Rope Inspection
It is a good idea to check the entire rope for wear and re spool it
neatly after every use. Check the winch rope for any cut strands,
fraying parts, abrasion, or heat damage from the winch. After
use, all winch lines will get a little fuzzy from abrasion. This is
normal, but
if an entire strand is cut the winch line needs to
be replaced or fixed . For the winch line to work properly and
maintain its strength, all strands must be intact.
Both heat and UV exposure break down the fibers of the
synthetic rope weakening it and making it brittle over time.
Frequent use in mud, dirt and sandy conditions can also
damage a synthetic rope if it is not properly cleaned and cared
for.
Cleaning Synthetic Rope
When dirt and grit become lodged in between the strands of the
winch line they cause abrasion to the fibers when the winch line
is put under a load. Over time this can cause a breakdown in the
integrity and strength of the rope.
Wash winch rope if it gets dirty by unspooling the entire line
from the winch and lay it on a clean surface. Once the line is
laid out, rinse it well with water from a hose.
To really get the strands free of dirt and grit, fill a bucket with
water and mild soap. Push together on the rope to open the
strands up and rinse in the water. Run the entire length of the
winch line through the water until it is cleaned.
7.9.2 Synthetic Chokers
Synthetic chokers are available as an accessory. These chokers
weigh less than the steel chain chokers and are easier to handle,
however are more susceptible to abrasion.
Before each use, check the condition of the choker for visible
damage. Replace if kinked, frayed, has knots, cuts, or any
broken strands. Failure to replace could result in breakage.
• Push the probe end of the choker under the log.
• Pull the ends together and push the probe end through the
loop.
• Attach the chain on the probe end to the keyhole slider on
the cable.
01606
Fig. 33 –
Synthetic Choker
• A synthetic choker is very susceptible to damage from
rubbing up against or sliding along rough ground or
surfaces.
• Synthetic choker strength can be reduced if subjected to
sudden jerking, or quick starts and stops. Avoid high shock
loads on the rope by starting slowly and smoothly.