Wallenstein FX40, Руководство оператора

Страница: 22 / 48

4.2 Installing PTO Shaft
The implement must be mounted to the tractor, and
fully lowered to the ground. Make sure tractor is shut
off with parking brake applied.
Check to make sure the shielding on the PTO shaft is
in good condition and able to turn freely, independent
of the PTO shaft.
Make sure the PTO yoke ends are clean. Adding a
small amount of lubricant on the splines can help them
slide on.
1. Install the PTO shaft on the implement. Press
the locking pin button and push the shaft end
onto the input PTO. Connect the safety chain to
the implement so that the shielding does not turn
during operation.
00866
Fig. 15 – Locking Pin Button
2.
Slide out the end of the PTO shaft up to the tractor
output PTO, aligning the two shaft splines. Press
the locking pin button and push the shaft end onto
output PTO.
3. Once started, slide the shaft all the way on. You
might hear a click and your button should retract to
the original position.
4. To check that the shaft lock is fully seated, pull
back on the shaft with your hands off the button.
5. Start the tractor and raise / lower the attachment
to check clearances. A correctly sized shaft should
never bottom out or come apart.
6. Check the rotation direction. A decal on the
machine indicates correct rotation.
5. Attaching Winch to Tractor
WARNING!
Never let anyone stand between the tractor and
the implement during hitching. Too fast of an
approach or the operator’s foot slipping from the
clutch can lead to injury or fatality to the person
standing nearby.
W048
Before hooking the winch up to the tractor, make sure
PTO shaft length is correct. If the length has not been
checked, see page 19.
Make sure there is enough room and clearance to
safely back the tractor up to the winch.
1. Move the tractor drawbar forward for clearance, if
required.
2. Place the tractor lift arms in their full sway position.
Remove the hitch pins from the winch.
3. At the slowest speed, back the tractor up keeping it
lined up with the winch.
4. When reversing, raise or lower the lift arms to align
them to the hitch pin holes on the winch.
00492
1 2
Fig. 16 – Align Tractor to Winch
1. Hitch Pin
2. Lynch Pin Retainer
5. Once properly aligned, apply the tractor park brake
and turn the engine off.
6. Slide a hitch pin through the lower lift arm holes
and hitch pin holes on both sides. Install the lynch
pin retainers on each pin.
7. Remove the top pin and install the top link.
Attaching Winch to Tractor
FX40
PTO-driven Log Skidding Winch
22