Wallenstein FX40, Руководство оператора

Страница: 17 / 48

3.3 Training
Each operator must be trained in the proper set-up and
operating procedures prior to being allowed to operate
the machine.
1. Review control location, function and movement
directions.
2. Move the unit to a large open area to allow the
operator to become familiar with control function
and machine response.
3. When a new operator is familiar and comfortable
with the machine, they can proceed with the
work. Do not allow untrained operators to use the
machine. They can endanger themselves and
others or damage property and the machine.
3.4 Job Site Familiarization
It is the responsibility of the operator to be thoroughly
familiar with the work site prior to starting. Prevent
the chance or possibility of problems or accidents by
not being in the situation to start with. Some items the
operators should check include but are not limited to:
1. Close or cramped work space. Be sure there is
sufficient space and clearance for the machine to
winch-in the log during operation.
2. Organize the working area to minimize the
winching and wood removal distances. The shorter
the distances, the faster the work will be finished.
3. Use care when pulling logs from a pile as they can
roll when attaching the rope or winching.
4. Position the tractor so prevailing winds blow engine
exhaust fumes away from operator.
3.5 Equipment Condition
1. Check the general condition of the winch. Make
sure that all nuts and bolts are secure and that a
moveable parts are secured and in their proper
place.
2.
Always inspect the rope as it is pulled out of the
winch. Do not use the machine if the rope is cut,
frayed, worn or knotted. Any problem can result
in early failure and create an unsafe operating
condition. Replace damaged rope before resuming
work.
FX40
PTO-driven Log Skidding Winch
Familiarization
17