Wallenstein CT24, Руководство оператора

Страница: 37 / 48

6.6.3 Hydraulic Oil, Changing
CAUTION!
Risk of burns to exposed skin.
Hydraulic oil becomes hot during
operation. Hoses, lines, and other
parts become hot as well. Wait for
the oil and components to cool
before starting any maintenance or
inspection work.
W028
Change the hydraulic oil in the reservoir at 100 hours of
operation or annually.
IMPORTANT! Change the return filter on the tank at the
same time.
• Hydraulic oil type: Dexron III ATF.
• Hydraulic oil tank capacity: 4.6 US gal (17.5 L).
The reservoir drain plug is located on the underside of the tank.
A 3/8" Allen wrench is required to remove it.
00539
3/8"
Fig. 45 –
Hydraulic Tank Drain Plug
1. Have a drain pan ready of suitable capacity.
2. Clean the area around drain and remove the drain plug.
3. Allow the oil to fully drain, then flush the tank. Dispose of
used oil in an environmentally acceptable method.
4. Re-install the drain plug.
6.6.4 Hydraulic Filter, Changing
1. The hydraulic system return filter is the spin-on type.
Remove the filter and dispose of it in an environmentally
friendly manner.
00537
Fig. 46 –
Hydraulic Oil Filter
2. Wet around the seal on the new filter with clean oil.
00538
Fig. 47 –
Oil the Seal
3. Turn the new filter on by hand until it is snug, then tighten
another 1/4 turn. Wipe off any oil residue on the filter and
filter head.
4. Fill the reservoir with clean, new oil. Verify the oil level
using the dipstick. The oil level should be at the upper
mark.
CT24
Trailer Firewood Conveyor
Service and Maintenance
37