Wallenstein BXTR6438F, Руководство оператора

Страница: 53 / 68

53
BXTR6438
5.12 Ledger Blades:
Each machine is equipped with a ledger (stationary) blade that acts as a shear for the moving rotor
blades.
The ledger blade is designed with 4 usable corners. When the corner facing the rotor blade rounds over,
remove the blade and re-install with a different corner facing the rotor blade. It is recommended that the
clearance between the rotor and stationary blades be set and maintained at 1/32 to 1/16 " (.76 - 1.52
mm) to obtain the best performance.
1. Ensure the engine is off (ignition switch
is off and the fuel valve is closed).
2. Remove the 2 bolts that hold the ledger
blade to the ledger mount, remove the
blade.
3. Rotate the blade and replace, or swap
with new or re-sharpened blade.
4. Hand tighten the bolts and set the
clearance between the ledger and rotor
blades at 1/32 - 1/16" (.76 - 1.52 mm).
For fast and easy setting, use our chipper
clearance setting gauge, available from
your dealer. (see accessories)
5. Tighten down bolts as specified in the
torque chart.
Ledger Blade
Ledger Blade
Bolts
5.13 Twig Breaker:
The Twig Breaker is a breaker tab located on side of the lower rotor housing. The discharge pad -
dle passes around the twig breaker and
helps to break the material into smaller
pieces and turn it into mulch. Inspect
the twig breaker for damage such as
gouges, a bent, or missing tooth. A dam -
aged twig breaker should be replaced. If
the tooth is showing wear, remove and
replace the twig breaker.
1. Ensure the engine is off. (ignition switch
is off and the fuel valve is closed)
2. Remove the 2 bolts and nuts that hold
the twig breaker to the housing, remove
the twig breaker.
3. Reverse the steps to install the new twig
breaker.
Twig Breaker
Twig Breaker
Bolts
Lower Rotor
Housing
Twig Breaker
Nuts