Wallenstein BXT72S, Руководство оператора

Страница: 23 / 76

5.2.1 Throttle Control
The throttle controls the engine speed. An operator can set the
engine to the minimum speed (
Slow ), the maximum speed
( Fast ), or to any speed that is between the minimum and
maximum.
Slow
Engine speed is slow.
Fast
Engine speed is fast.
5.2.2 Tachometer and Hour Meter Display
Tachometer When the engine is on (the ignition switch is in
the RUN position), the display shows the current
engine revolutions per minute (RPM).
Hour meter While the engine is in the process of starting or
stopping the display shows the total number of
hours that the engine has been on since it was
manufactured. This number cannot be reset.
5.2.3 Check Engine Light
The red check engine light communicates the following
information:
Light Engine Status
On The engine is in the process of starting or
stopping.
Flashing There is an electronic fuel injection (EFI)
malfunction.
Off The engine is off or on.
5.2.4 Ignition Switch
WARNING!
The engine can cause serious bodily harm
or death to a person who is not trained in the
correct operation. Always remove the key
and keep it in a safe location to prevent an
unauthorized person from starting the engine.
W113
IMPORTANT! Long start cycles can decrease the life of the
starter. Use short start cycles (five seconds maximum) and
wait one minute between cycles.
IMPORTANT! Use the ignition switch to stop the machine,
except in an emergency. When the ignition switch is in the
RUN position and the engine is stopped, it can damage the
battery.
The key-operated ignition switch controls the electric power to
the engine. The ignition switch has the following positions:
STOP
STOP
The engine is off and the fuel shut-off valve is
closed.
RUN
RUN
The engine is on.
START
START
Engine ignition.
When the engine starts, the key turns to the
RUN position.
BXT72S
Wood Chipper
Controls
23