9. Service and Maintenance
Regular preventive maintenance can improve performance and
prolong the life of the machine. Machine maintenance is your
responsibility.
9.1 Service and Maintenance Safety
WARNING!
Before you start service or maintenance work:
• Set the machine to a safe condition.
• Wait for the machine to cool down. Engine
components and fl uids may be hot enough to
cause burns.
• Read and understand all of the service and
maintenance safety information.
W041
WARNING!
Wear the personal protective equipment (PPE)
that is necessary to do the work safetly.
This includes, but is not limited to, a hard hat,
hearing protection, a face shield, protective
footwear, a respirator, and heavy gloves.
W101
WARNING!
After service and maintenance, install all of the
guards and shields, and close all of the covers.
Do not operate the machine with any guard or
shield removed, or cover open.
W110
Set the machine to a safe condition before you start any
service or maintenance:
SAFE CONDITION
1.
If the machine is connected to a tow vehicle, set the tow
vehicle's parking brake, stop the engine, and remove the
ignition key.
2.
Stop the machine.
For instructions, see
3.
Disconnect the engine spark-plug wire and keep it away
from the spark plug.
4.
Disconnect the cable from the negative (-) battery
terminal and keep it away from the battery.
5.
Remove all material from the chipper hopper.
6.
Wait until the engine and machine are cool.
•
Follow good shop practices:
• Keep the work area clean and dry.
• Ground electrical outlets and tools.
• Have sufficient light for good visibility.
•
Use tools that are in working condition and correct for the
task. Make sure that you know how to use the tools before
you use them.
•
Only operate the engine in a location that has good air
flow. Engine exhaust gases contain carbon monoxide (an
odorless gas) that can cause asphyxiation.
•
Do not work under equipment unless it is safely supported
with blocks.
•
Do not do service or maintenance work alone. Always have
a minimum of two people in case an emergency situation
occurs.
•
Keep a fire extinguisher and first aid kit available at all
times.
•
When service or maintenance is complete, do the following:
• Replace all guards and shields, and close the covers.
• Torque the fasteners to the correct specifications.
• Make sure that all the electrical, hydraulic, and fuel
connections are connected in a safe working condition.
•
Do not use gasoline or diesel fuel to clean parts. Use the
correct cleaning product.
•
When replacement parts are necessary, use genuine
factory replacement parts to restore your machine to
the original specifications. The manufacturer cannot be
responsible for injuries or damages caused by use of
unapproved parts and/or accessories.
Service and Maintenance
BXT52S
Wood Chipper
48
Содержание BXT52S
Страница 36: ...02283 Figure 22 Set up the machine Operating Instructions BXT52S Wood Chipper 36...
Страница 42: ...02281 Figure 28 Transport position Transport BXT52S Wood Chipper 42...
Страница 46: ...02282 Figure 32 Storage position Storage BXT52S Wood Chipper 46...
Страница 76: ...WallensteinEquipment com...
