Wallenstein BXMT4224, Руководство оператора

Страница: 30 / 52

• Do not reach into the shredder feed hopper further than the
gate to avoid contact with the knives on the rotor.
• Use a stick or branch to push any piece of material into
the knives that does not move on its own and stops in the
chipper housing.
CAUTION!
Keep shredder gate closed between feeds to
keep fl ying material contained in the shredder
housing. Do not prop open the gate. Material can
fl y out causing injury.
W071
• Release the handle so the gate closes. Ensure the gate is
closed between feeds to keep flying material contained in
the shredder housing. Do not prop open the gate.
6.9 Machine Break-In
Although there are no operational restrictions on the wood
chipper when used for the first time, it is recommended that the
following mechanical items be checked:
After 1–5 hours of operation:
1. Review the engine operator's manual for break-in
information.
2. Inspect the axle, tires, and wheel hubs. Check wheel nut
torque.
3. Check tire pressure. Refer to tire sidewall and inflate as
required.
4. Check drive belt alignment. Re-align if required. See page
37.
5. Check belt tension. Adjust if required. See page 37.
6. Visually check condition of rotor bearings. Make sure they
are not overheated and turn freely.
7. Check the condition and clearance of the twig-breaker, rotor
and ledger blades. Adjust as required. See
page 40.
8. Check for entangled material. Remove all entangled material
before resuming work.
9. Check torque on fasteners and hardware.
After 8 hours of operation:
10. Repeat all previous steps.
11. Perform all the checks in the Pre-operation Checklist .
6.10 Clearing a Plugged Chipper
The chipper is designed to handle a wide range of materials
without any problem. However, in the event material gets lodged
in the chipper, follow this procedure to clear the blockage.
WARNING!
Never reach into the feed hopper. Doing so risks
hands getting caught. Use a stick or branch to
push in any material that does not move on its
own.
If jammed, stop the engine, wait for the rotor to
stop, then clear the jam.
W004
1. Stop the engine. Wait for all moving parts to stop.
2. Pull any material out of the chipper hopper and shredder
hopper. Be sure all the material is out, and nothing is
jammed or wedged between the input opening and the
rotor.
3. Pull any material out of the discharge hood. Use a stick to
poke any material loose jammed into the discharge hood.
Do not allow anything to remain in this area.
4. Try restarting to see if the jam is cleared.
If the chipper is still plugged, the jammed material must be
removed by hand.
CAUTION!
Avoid reaching into rotor compartment. Rotor
chipper blades are very sharp. If reaching inside
is necessary, use extreme care.
W003
5. Place the machine in a safe condition. See page 7.
6. Loosen the upper rotor housing anchor bolt and open the
rotor housing.
01041
Fig. 22 – Upper Rotor Housing Bolt (typical)
7. Remove jammed material from inside the chipper rotor and
shredder compartment.
8. Clean out the discharge area rotor paddles.
Operating Instructions
BXMT4224 / BXMT4238
Trailer Chipper-Shredder
30