Wallenstein BXMT Series, Руководство оператора

Страница: 38 / 48

1. Loosen the ledger knife bolts and adjust it inward. Snug the
bolts by hand.
2. Turn the rotor around so that one of the rotor blades is
directly in line with the ledger knife.
3. Tap the ledger knife inward toward the rotor blade. Use
the clearance setting gauge to set clearance between the
two. If one is not available, set the clearance to 1/32–1/16"
(1 – 1-1/2 mm).
4. Tighten the bolts to 33 lbf•ft (45 N•m) .
Sharpening
All four corners of the knife can be used. In the event all four
corners of the blade have rounded over, remove the blade to
sharpen it.
1. Sharpen both long edges of the blade at 90°.
01098
90°
90°
Fig. 42 – Sharpening Ledger Knife
2. Reinstall the blade and set proper clearance. Tighten bolts
to proper torque setting.
7.9 Chop Block
Observe chop block function at each use. Sharpen or rotate
every 50 hours of operation.
The chop block is bolted in at the bottom of the upper rotor
housing. Its purpose is to help break material into smaller pieces
and turn it into mulch as the shredder knives pass when the
rotor is turning.
Inspect the chop block for damage such as gouges, or bent,
missing teeth. A damaged chop block should be replaced. If
teeth are showing wear, the chop block can be turned around
and installed the other way.
01099
Fig. 43 – Chop Block in Rotor Housing
Service and Maintenance
BXMT3209
Trailer Chipper-Shredder
38