Wallenstein BXC34, Руководство оператора

Страница: 32 / 52

Storage
BXC34 / BXC34 Bundle
Wood Chipper
32
8. Storage
At the end of the season or when the machine is not going to
be used for an extended period of time, completely inspect all
of the major systems. Replace or repair any worn or damaged
components to prevent unnecessary down time at the beginning
of the next season. Touch up scratches or dents.
8.1 Storage Safety
WARNING!
Do not permit children to play on or around
stored machinery or equipment. Sharp edges,
unexpected movement, trips, falls, and other
hazards can cause serious injury or death.
W105
• Store the machine in a dry, level location away from human
activity.
• Store the machine indoors, where possible.
8.2 Place the Machine in Storage
For information about engine storage, see the engine
manufacturer's manual.
1. Set the machine to a safe condition.
For instructions, see
Safe Condition on page 9 .
2. Check all of the moving parts and remove all entangled
material.
3. Use a pressure washer or water hose to thoroughly wash
the machine. Remove all dirt, mud, and debris.
4. Start the machine, let it run for a few minutes to remove
any moisture, and then stop the machine.
5. Thoroughly inspect the machine, including the drive belt
and pulley. Replace or repair any worn or damaged parts.
6. Complete one of the following:
-
If the machine will be in storage for one to three
months, add stabilizer to the engine fuel and drain the
carburetor.
-
If the machine will be in storage for longer than three
months, replace the engine fuel with an alkylate or
appropriate engineered fuel. These fuel types prevent
the buildup of insoluble solids (deposits) in the engine.
For more information, see
Engine Fuel on page 34 .
For instructions, see Replace the Engine Fuel on page
32 .
7. Park the machine in the storage location.
8. Block the machine wheels to prevent accidental movement
and increase the wheel bearing life.
9. If indoor storage is not possible, cover the machine with
a waterproof tarp. It is recommended that the machine be
stored indoors.
8.2.1 Replace the Engine Fuel
1. Remove the current fuel from the engine.
Operate the machine until the fuel tank is empty or drain the
fuel tank and properly dispose of the fuel.
2. Add new fuel to the engine.
For instructions, see
Add Fuel to the Engine on page 25 .
3. Start the machine.
For instructions, see
Start the Machine on page 27 .
4. Wait five to 10 minutes for the fuel to flush the carburetor.
5. Stop the machine.
For instructions, see
Stop the Machine on page 27 .
8.3 Remove the Machine from
Storage
1. Complete the Pre-Start Checklist on page 23 .
2. Complete the required maintenance.
For maintenance requirements, see the
Maintenance
Schedule on page 35 .