Safety Signs
BXC34 / BXC34 Bundle
Wood Chipper
Safety
16
7. Caution!
Risk of personal injury!
Do not put material larger than 3"
(75 mm) in diameter into the chipper.
Material that is larger than the size
stated on the safety sign can stall the
engine, damage the machine, or cause
personal injury.
8. Caution!
Risk of injury from flying debris!
Stay clear of material discharge chute.
Machine can expel wood chips fast
enough to cause injury.
Do not point discharge at people,
animals or buildings. Point chipper
discharge away from work area and
bystanders. Keep a safe distance from
discharge.
9. Warning!
Risk of cancer and
reproductive harm
The machine materials
contain chemicals or
machine operation may
produce gases or dust that
are identified by the state
of California as causes of
cancer, birth defects, or
other reproductive harm.
This warning is required by
the state of California, USA
to comply with Proposition
65: the Safe Drinking Water
and Toxic Enforcement Act
of 1986.
3.3 Replace Damaged or Missing
Safety Signs
•
Always replace safety signs that are missing or have
become illegible. Replacement safety signs are available
from your authorized distributor, dealer parts department,
or Wallenstein Equipment.
•
Keep the safety signs clean and legible at all times.
•
Parts replaced that had a safety sign (decal) on them must
also have the safety sign replaced.
Requirements
•
The installation area must be clean and dry.
•
The application surface must be clean and free of grease
or oil.
•
The ambient temperature must be above 50 °F (10 °C).
•
A squeegee, plastic bank card, or similar tool is required to
smooth out the decal.
Procedure
Determine the exact position for the decal before
removing the backing paper. If possible, align the
decal with an edge on the machine.
1.
Peel the decal off the backing paper.
2.
Position the decal above the location where it is being
applied to the machine.
3.
Starting at one edge, carefully press the center of the
exposed sticky-backing in place, smoothing it out as you
work from one side to the other.
4.
Use an appropriate tool to smooth out the decal, working
from one end to the other.
Small air pockets can be pierced with a pin and smoothed
out using a piece of the decal backing paper.
