Wallenstein BX52RI, Руководство оператора

Страница: 52 / 72

Service and Maintenance
BX52R, BX72R, BX102R
3 PH Roller-feed Chipper
52
7.3 Maintenance Schedule
Perform maintenance procedures at time shown or hour
interval, whichever comes first.
As Required
Check the condition of all hydraulic lines, hoses and fittings. Replace
any that are damaged.
Remove entangled material from chipper.
Lubricate hinges and pivot points.
Every 8 hours or Daily
Grease PTO Shaft
See this page, and page
56
Check hydraulic oil level
Perform Pre-operation check See page 42
Every 50 hours or Annually
Check rotor blade sharpness See page 56
Check ledger knife sharpness See page 57
Check twig breaker See page 56
Grease entire machine See page 51
7.4 Grease Points
IMPORTANT! Use a hand-held grease gun for all greasing.
Pump one shot of grease per fitting.
• Wipe grease fitting with a clean cloth before greasing to
avoid injecting dirt and grit.
• If fittings do not take grease, remove and clean them
thoroughly. Replace grease fittings as necessary.
Location
Grease Points
– Every 8 hours of operation
1 PTO Shaft Universal Joints
2 PTO Shaft Slip Joint
00867
1
1
2
Fig. 66 –
8-hour Grease Points