Attach to a Tractor
BX52R, BX72R, BX102R
Tractor Wood Chipper
26
5.4 Connect Hydraulic Hoses
WARNING!
Hydraulic oil under pressure can penetrate the
skin or eyes causing serious injury.
• Tighten all connections before applying
pressure.
• Search for leaks with a piece of cardboard
or wood, not your hand. Take care to protect
hands and body from high-pressure fl uids.
Wear a face shield or goggles for eye
protection.
• If an accident occurs, see a doctor familiar
with this type of injury immediately.
W040
Hydraulic power from the tractor is required to drive the feed
rollers.
1.
Clean any dirt from the quick-disconnect couplers on the
tractor.
2.
Route the hoses to avoid binding or pinching, then connect
them to the tractor couplers.
The protective caps on the hoses are colored to indicate
function—red is the pressure line, black is return.
Additionally, the return line has an arrow on the in-line check
valve to indicate oil flow direction.
00827
1
2
Fig. 23 –
Hydraulic Hoses
1. Pressure Line to Chipper (red cap)
2. Return Line to Tractor (black cap)
5.5 P3 PULSE Equipped Models
The following models include a P3 PULSE electronic control
system:
•
BX52RI
•
BX72RI
•
BX102RI
•
BX102RPI
Models equipped with a P3 PULSE electronic control system
require a 12 VDC, 2-amp power supply from the tractor.
Connection must be to a (14.5 V) charging battery.
1.
Route the harness across the tractor hitch to avoid rubbing
or chafing.
2.
Connect the positive (+) red wire to the 12 VDC supply on
the tractor.
3.
Connect the ground (-) black to the ground connection on
the tractor.
00886
Fig. 24 –
P3 PULSE Electrical Connection
