Wallenstein 720123, Руководство оператора

Страница: 29 / 44

WXR720/L, WXR740/L
Trailer Wood Splitter
Operating Instructions
29
6.13 Log Placement
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
• Always grasp the log by the sides not the ends
when placing in or removing logs from the
splitter. This minimizes the chance of the operator
getting fingers, hands or arm between the wedge /
push block and the log.
• Any logs or debris remaining on the splitter bed
should only be removed after it is safe to do so.
00204
Fig. 23 – Correct Log Placement
6.14 Splitting Logs
WARNING!
Risk of pinching or crushing hazard! The worker
loading the splitter MUST be the only one in
control of the hydraulic cylinder and splitting
wedge.
Only one worker should operate and load the
wood splitter.
W036
1. Place wood or log on the splitter.
2. Move control lever to the High Speed position (2)
until push block or wedge starts to split the wood.
3. If the wedge slows, push control lever forward to
High Power position (1) and hold to split wood.
4.
Release the lever when the log splits or cylinder
reaches full stroke and stops.
5. Pull the lever back to retract the push block or
wedge. The detent holds the lever until the cylinder
fully retracts, allowing hands-free operation.
IMPORTANT! Do not hold the valve lever to
extend or retract the cylinder once it has reached
the end of its stroke. Doing so can overheat the oil
and damage the engine.
6. If the log is large enough to require another split,
reposition and repeat steps.
00193
2 3 4 1
Fig. 24 – Hydraulic Control Valve Positions
1. High Power
2. High Speed
3. STOP (Neutral)
4. Retract
Pile the split wood close to the working area, but do not
allow pieces to pile up and clutter the area. A cluttered
working area can lead to tripping and an accident.