Wallenstein 1C34423, Руководство оператора

Страница: 23 / 44

BXC34
Cart Chipper
Operating Instructions
23
6.6 Fuel Level Check
Check the fuel level before each use. Starting with a full tank
helps to eliminate or reduce operating interruptions for refueling.
The fuel tank is located on the engine. Avoid running the tank
dry.
00198
Fig. 17 –
Fuel Filler Cap
6.6.1 Refueling
Fuel tank capacity: 0.95 US gal (3.6 L).
WARNING!
Fuel vapors can explode causing
injury or death. Do not smoke while
refueling. Keep sparks, fl ames, and hot
components away.
W027
Refuel in a well-ventilated area with the engine stopped. If the
engine has been running, allow it to cool first. Never refuel the
engine inside a building where gasoline fumes can come in
contact with flames or sparks.
For fuel specification, see Fluids and Lubricants on page 29 .
Refer to the engine manual for additional information on fuels.
1. Clean the area around fuel tank cap. Fill the tank to 1/2”
(12 mm) below bottom of filler neck to provide space for
any fuel expansion. Do not overfill.
2. Install fuel fill cap securely and wipe up any spilled fuel.
6.7 Engine Air Cleaner
A dirty air filter can restrict air flow to the carburetor, reducing
engine performance. If the engine is operated in very dusty
areas, clean the air filter more often than specified
.
IMPORTANT! Operating the engine without an air filter or
with a damaged air filter can allow dirt to enter the engine,
causing rapid engine wear. This type of damage is not
covered by warranty.
Inspection
Remove the air cleaner cover and inspect the filter elements.
Clean or replace dirty filter elements. Always replace damaged
filter elements.
NOTE: Refer to the engine manual for further information
on servicing the air cleaner.
01187
Fig. 18 –
Engine Air Cleaner
6.8 Machine Set-up
CAUTION!
Park the machine so prevailing winds blow
exhaust gases / fumes away from the operator.
W006
CAUTION!
Do not use chipper/shredder on uneven ground.
Machine may tip over resulting in personal injury
or damage to the machine. Chipper/shredder
must be resting on the level and stable ground
during operation.
W038
1. Position the chipper at the work site close to the brush pile.
2. Ensure that the machine is resting on the ground and is
level and stable, and the work area is free of debris.
3. If the machine is attached to a lawn tractor, apply the
brakes and chock the wheels.
4. Ensure the feed hoppers are free of debris (to prevent
jamming at start up).
5. Position the discharge chute as required, pointing away
from people or animals.