Wallenstein 1102R215, Руководство оператора

Страница: 51 / 72

BX52R, BX72R, BX102R
3 PH Roller-feed Chipper
Service and Maintenance
51
7. Service and Maintenance
Good maintenance is your responsibility. Poor maintenance is
an invitation to trouble.
7.1 Safety Rules
• Follow good shop practices:
-
Keep service area clean and dry.
-
Be sure electrical outlets and tools are properly
grounded.
-
Use adequate light for the job at hand.
• Never operate the tractor engine inside a closed building.
The exhaust fumes may cause asphyxiation.
• Place machine in a Safe Condition before servicing or
repairing. See page 7.
• Allow the machine to cool before performing
maintenance. Components and oil may be hot enough to
cause burn injury.
• Never work underneath equipment unless it is blocked
securely.
• When performing any service or maintenance work
always wear proper PPE for the job.
• Where replacement parts are necessary, genuine factory
replacement parts must be used to restore equipment
to original specifications. The manufacturer is not
responsible for injuries or damages caused by use of
unapproved parts or accessories.
• Inspect and tighten all bolts, nuts and screws. Check
that all electrical and hydraulic connections are properly
secured to ensure chipper is in a safe working condition.
• After completing a service procedure, make sure all
covers and shields are reinstalled.
• When cleaning any parts, do not use gasoline or diesel
fuel. Use a regular cleanser.
• Always use proper tools in good condition.
WARNING!
Risk of serious personal injury. Stop engine
before performing ANY service or maintenance
procedure. Reinstall all covers and guards
removed before putting machine back into
service.
W033
WARNING!
Shut down the machine and allow it to cool
before performing any service, maintenance, or
inspection procedure. Engine components and
oil may be hot enough to cause injury.
Make sure the machine is in a Safe Condition to
work on. Review Maintenance Safety beforehand.
W041
Safe Condition
-
Ensure chipper is resting on the ground.
-
Disengage PTO.
-
Set parking brake and shut off tractor engine. Remove
ignition key.
-
Ensure all components have stopped moving.
-
Block and chock tractor wheels.
-
Set rotor lock if required.
7.2 Fluids and Lubricants
1. Grease Type
Use an SAE multi-purpose high temperature grease with
extreme pressure (EP) performance. Also acceptable is an
SAE multipurpose lithium-based grease.
2. Hydraulic Oil
The chipper uses the hydraulic oil from the tractor circuit.
3. Storing Lubricants
Your machine can operate at top efficiency only if clean
lubricants are used. Use clean containers to handle all
lubricants. Store them in an area protected from dust,
moisture and other contaminants.