Wallace Perimeter Security FOLDSMART, Руководство по установке и обслуживанию

Страница: 41 / 162

FoldSmart™ Installation and Maintenance Manual Revision 1 - MAY 2023
41
INSTALLATION ADJUSTMENTS
5. Once adjusted so that the gate panels are
square at a 90-degree angle to the roadway,
tighten the nuts on either end of the drawbar
to lock in the current position.
6. Ensure traffic, both pedestrian and vehicle,
is clear and then test the gate by pushing the
OPEN push-button on the SmartDC control
board.
7. Ensure the open limit is suitable and the gate,
when closed, does not bind on the steel vertical
catches. If there is binding, further adjust the
drawbar or limit switches as needed.
Limit Switch Adjustment
Procedure
The FoldSmart gate uses limit switches to identify
the open and closed positions. The open and
closed positions can be modified by adjusting the
point at which the switches are triggered.
2. To access the limit switches, first remove the
motor/gearbox housing covers. You will need
a Torx T27 bit to remove the fasteners. If using
a drill or impact driver, set to a slow speed to
avoid damaging the fasteners and/or bit.
The limit switch adjustment is
done in conjunction with the
drawbar adjustment. Refer to
the preceding instruction set for
Drawbar Adjustment Procedure.
1. Each motor/gearbox assembly will have its
own pair of limit switches.